Formfutura StoneFil - Concrete (1.75mm 500 gram)
Pickup currently unavailable at 7A Kent Street, Yarraville, VIC
7A Kent Street, Yarraville, VIC
7A Kent Street
Yarraville VIC 3013
03 9687 8638
- Easy to print
- 50% gravimetric powdered stone filling
- ±37% heavier than “normal” PLA
- Matte and rough stone-like finish
General printing guidelines *
|Nozzle size: ≥ 0.4mm||Layer height: ≥ 0.2mm||Flow rate: ± 110%|
|Print temp: ± 215 - 230° C||Print speed: Slow||Retraction: Yes ± 5mm|
|Heat bed: ± 0 - 60° C||Fan speed: 50-100%||Experience level: Beginner|
AbrasivenessStoneFil has a very high filling with stone powders and therefore the filament can have a slightly more abrasive effect on brass nozzles than unfilled filaments.
|ρ: 1.70 g/cc||50 gr coil||0.5 Kg spool|
|Ø 1.75mm||± 12.2m||± 122m|
|Ø 2.85mm||± 4.6m||± 46m|
Nozzle cleaningWhen printing with filled/composite filaments it is recommended to clean your nozzle immediately after printing by feeding 15-20cm PLA filament through your nozzle. This will make sure that any potential fillers are flown out of your nozzle. It is even better to use glow in the dark PLA as the extremely hard phosphorous particles are much more likely to scrape out residual waste from your nozzle.
Product export information
|HS Code: 39169090||Description: Monofilament||Country of origin: the Netherlands|
Compliance *This filament is compliant to below listed directives and regulations.
- RoHS directive 2011/65/EC
- REACH directive 1907/2006/EC